...fit mud flaps
- Rear TF mud flaps
- Front TF mud flaps
- Very easy to fit, you don't even have to remove the road
wheels. Just follow the instructions that come with the kit.
|
...fit side
vent mesh
|
...fit the rear
bumper mesh
- Part numbers...
- DQY000120PMD - Grille-rear bumper - Black
- DQY000130MMM - Grille-rear bumper - Chrome
- ...to a TF
- Once again, Spike-UK shows us how to
fit them
here.
- Garvin also has the know how for us
here.
|
....remove the
air vents
|
|
...replace the
front / rear MG badge TIP !! Before you replace a delaminating
badge, give it a few coats of clear lacquer, this will seal the
badge and prolong the delamination.
The part number for both the front and rear badges is DAB000160,
the size of both the front and rear badges is 70mm.
- Several ways to remove the old badge. I found the following
worked well, this should work on both the front and rear badges.
Using a hair dryer, heat the badge to soften the sticky pad on the
back of the badge. Using some fishing line, work it behind the badge
as if you were flossing it. You will not be able to get all the
way through because of the two pins in the centre. When you've finished
flossing, put some tank or gaffer tape around the badge for protection,
using a plastic spatula, carefully prise off the badge. With the
badge removed, clean off any sticky pad that's been left behind.
Fit the new badge, the two pins align the badge, remove the protective
covering from the back of the badge and press it firmly in place,
remove the tape protection, job done.
- Zilla on the MG-Rover.org forum created
this thread describing how to replace faded badges.
|
...front bumper
- ...removal on an F
- Broon shows the procedure
here from his web site.
- Dave Morris, 'Red Leader' on the SWMGF boards
produced this how to on F front bumper removal (you need
to be a SWMGF member to view the thread).
- ...removal on a TF
- ...fitting an LE500 bumper to a TF
|
...rear bumper
- ...removal on an F
- Andy Phillips shows the procedure
here on the F register forum.
- ...removal on a TF
- this
'How To' by Spike for rear mesh fitting can also be used
to show how the rear TF bumper is removed.
- CJJ from the MG-Rover.org forum
posted another great thread complete with photo's showing
the removal of his rear bumper.
|
...replace
a Mk 1 F's speedo cable
|
...Rear screen
- fit a
glass rear screen into a MkII frame
- Adam Elphick defied us all and managed to fit a glass rear screen
into his MkII hood frame,
click here to find out how he did it.
The thread that followed his progress
is here on the MG-Rover.org forums.
- replace the plastic rear screen
|
...make a
TF air vent scoop
- CJJ on the MG-Rover.org forum, has produced
yet another great How To, this time its how to make an air vent
scoop for the TF.
|
...change a door handle
- MG_CHIC on the MG-Rover.org forum,
posted this thread showing how to change your door handles,
complete with very helpful photos.
|
