|
|
Interior
- Seats
- Door Cards
- Stephan Gribney's
Ultimate MG
site has a section on how to remove the door card panel in his FAQ
section.
- Seat belts
- FSU, a member of the MG-Rover.org forum, has come up with an
alternative to the usual seat belt tidy options. This is his description,
followed by photographs.
"Select a leather belt 2” wide in my case and quite supple leather.
With a sharp knife cut two strips each 25cm (10”) long. Taking each
strip individually fold over so that both the cut edges are together
– one on top of the other. Clamp between two pieces of wood – I
used 4mm plywood – and make sure the ends of the leather strip is
visible. Drill a 10mm hole – using a sharp wood drill – with the
centre of the hole approx 2.5 cm from the cut edge and central to
the strap.
Remove head rests – remember that the plastic holder on the seat
needs to be turned clockwise (1/4 turn) to allow them to come out
completely.
Fold leather strap around the seat belt and push the appropriate
head rest shaft through the two holes. Refit head rest to seat and
check seat belt operation"
- T-Bar
-
This page at DotComoff, written by Andy 'Scarlet Fever' Phillips,
gives the low down on T-bar removal.
- Badly fitting carpets
-
This is a post from Per (lagerpe) on MG-Rover.org with a great
tip for you ill fitting carpets.
- Here's a tip from Jerry 'MGtfnut' Herbert for ill fitting carpets
- "Loosen the seat fixing bolts to the floor, and pull the carpet
out towards the sills, then tighten up. No need to fiddle
with the SRS etc. Normally the carpet edge will then tuck in behind
the soft plastic finisher as intended."
- Stephan Gribney's
Ultimate MG
site has a section on how to get the rear shelf carpet to fit better
in his FAQ section.
- Roll hoops
- For those of you with the type of roll hoop that goes through
the T-bar,
here is a great tip from Tony Thompson's site. If you had the
OE mesh wind stop fitted, this tip will cover the hole that is left
behind.
- Iain Ross shows how to remove the Mike Satur roll hoops
here.
- Gear Stick
- Shortening the MGF gear stick courtesy of Dieter
here.
- Shortening the MGTF gear stick courtesy of me....
Before you start, make sure your gear knob will fit over the gear
stick shoulder, The Momo knob I fitted was perfect for this. so,
remove the gear knob. Place a cloth over the gear stick. Hack off
the top 30mm. Run an M10 die down the remaining shaft, up to the
shoulder. Remove the cloth and swarf. Refit gear knob.
|
